Description Specification: Type: Light curing composite resin Shade: A1, A2, A3 Net weight: 2.5g Color: As shown in picture Quantity: 1 piece Features: 1. Low polymerization shrinkage 2. High strength and polishability 3. Similar modulus of elasticity to dentin 4. Radiopaque and fluoride releasing 5. Optimal polishability and high shade stability 6. Easy to mold 7. Easy to adhere to bracket for orthodontics 8. Simple and convenient to use 9. Suitable for all types of cavity preparations Usage: 1. Prepare cavities according to standard procedures, remove decayed tissue, and clean the cavity. 2. Apply a dental etchant to the tooth surface to be bonded, then rinse and dry thoroughly. 3. Apply a thin, uniform layer of dental adhesive to the bonding surface and cure with a dental light-curing unit for 20 seconds. 4. Fill the cavity with an appropriate amount of composite resin. Cure with a light source of at least 400 mW/cm² for 20 seconds. Curing depth is up to 1.5 mm. For deeper fillings, extend curing time or perform incremental layering. 5. Trim and polish the restoration. Use dental articulating paper to check occlusion. It is recommended to use rubber polishing points and ultra-fine abrasive polishing strips. 6. When indicated, use pulp protection materials such as calcium hydroxide (light-cured or chemically cured) or other non-eugenol liners. Do not use eugenol-containing materials directly under the restoration. Indications: Restorative material for non-occlusal cavity repairs Warnings: Close the cap immediately after use to prevent exposure to light. Use with caution in cases of pulp inflammation. If the pulp is exposed or nearly exposed, perform proper pulp capping and protective treatment before placing the restoration. Other pulp conditions should be treated prior to restorative procedure. Storage: Store at room temperature and protect from direct sunlight.