Normal mode: approach the foot of the bumper sensing area and then leave the bumper sensing area. When this action is completed, a trigger signal be generated.Abnormal patterns: stairs, stones, branches, rough roads, plastic bottles, car wash, etc., no trigger signal is generated and high qualityType: car kick sensorInstallation Notes:1. Find the proper position on the rear guard of the vehicle.2. Wipe the installation position of the sensor.3. Peel off the double-sided tape of the sensor (the side of the double-sided tape is the detection ) facing the ground4. Connect the sensor firmly to the rear protective plate (inside of the bumper)! The sensing should avoid metal objects such as iron and aluminum.Second, after power-on test, wait for 20 seconds after power-on. After the product self-test is completed, you can do kicking or sweeping movements under the sensor.1. The sensor can only recognize one action, either kick once or sweep once2. After each action is completed, you need to wait 2 seconds before continuing the operationThird, the product's working characteristics, one kick cannot be used after the car is started, and one kick is used normally after the flame is turneColour: blackMaterial: plasticPackage Contents:1 set x sensor with wiring harnessOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.