1、Single channel USB to serial / parallel ports with a variety of configurations. 2、Whole USB protocol handled on the chip, no USB specific firmware programming required. 3、USB 2.0 high-speed (480Mbits/Second) and full speed (12Mbits/Second) compatible. 4、Multi-protocol synchronous serial engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design. 5、UART data transfer rate up to 12Mbaud (RS232 data rate is limited by external level shifter). 6、USB to synchronous 245 parallel FIFO mode transfer up to 40 megabytes/second. 7、USB to asynchronous 245 fifo mode data transfer rate up to 8 megabytes per second. 8、Support for special half-duplex FT1248 interface with configurable width, bidirectional data bus (1, 2, 4 or 8 bit wide). 9、CPU - style FIFO interface mode simplifies CPU interface design. 10、Fast serial interface option. 11、FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases. 12、Adjustable receive buffer timeout. Condition: Brand NewItem Type: USB to JTAG UART/FIFO SPI/I2C ModuleTypical ApplicationsSingle chip USB to UART (RS232, RS422 or RS485)USB to FIFOUSB to FT1248USB to JTAGUSB to SPIUSB to I2CUSB to Bit-BangUSB to Fast Serial InterfaceUSB to CPU target interface (as memory)<div class="wang-edit-text"><style>.w-e-text table td,.w-e-text table th,.wang-edit-text table td, .wang-edit-text table th{border: .5pt solid #000;};.w-e-text table,.wang-edit-text table{border: 1px solid #000 !important;}</style> 1 x Module3 x Pin Header