[Wide Voltage]: Wide voltage input 7-70V, maximum output current 30A. Recommended power range: 12V within 250W, 24V within 350W, 48V within 450W, and 60V within 500W. [Speed Control Knob]: The knob includes a switch function to control motor speed from 0% to 100%. Features an adjustable potentiometer with a flexible cable that can be detached. Cable length is 15CM. [30A Fuse]: Includes a 30A fuse to protect against short circuits at the motor interface. Provides double protection for your motor and motor speed controller. [Note 1]: Input power supply must be 1.5 times the rated power of the motor for proper operation. Input voltage must match the motor's rated voltage. [Note 2]: If the children's car has a forward-reverse circuit regulator, connect the speed controller between the power supply and the forward-reverse circuit regulator. Failure to do so may damage the speed controller. Precautions: This module is a DC motor speed controller and must not be connected to AC power. Input power supply must be 1.5 times the motor’s rated power. Input voltage must match the motor’s rated voltage. Modification for Children's Car: When used in children's car modifications, connect the output end of the speed controller to a forward and reverse switch to enable forward and reverse control. If the vehicle has a forward-reverse circuit regulator, install the speed controller between the power supply and the regulator to prevent damage. Specification: - Type: DC Motor Speed Controller - Voltage Range: DC 7-70V - Drive Current: Max 30A (refer to recommended control power for actual usage) - Recommended Load Power: - 12V: up to 250W - 24V: up to 350W - 48V: up to 450W - 60V: up to 500W - Duty Cycle Adjustment Range: Approximately 1% - 100% - PWM Frequency: 12KHz - Fuse Rating: 30A max - Wire Diameter: 2.5mm² / 0.4cm diameter / 12AWG - Wire Length: 26cm (total length including connector 30cm) - Material: ABS - Color: As shown Package Contents: 1 x DC Motor Speed Controller Note: Other items not included. Slight color variations may occur due to lighting and display differences. Measurement error allowed: +/- 1-3cm.