DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

379,00 kr
gratis leverans

DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

  • Märke: Unbranded
Säljs av:

DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

  • Märke: Unbranded

379,00 kr

Spara 270,00 kr (41%)

RRP

649,00 kr
I lager
gratis leverans
Säljs av:

379,00 kr

Spara 270,00 kr (41%)

RRP

649,00 kr
I lager
gratis leverans

Vi erbjuder följande betalsätt

Beskrivning

DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

This kit uses ARM Cortex-M3 processor (STM32F103C8), and includes a 2.4-inch color TFT display screen, can be used as ARM test development board. Can be secondary development on the basis of this kit, for example, it can be changed to Millivoltmeter, With automatic, regular and one-shot modes, easy to capture the moment waveform. Comes 1Hz or 3.3V square wave test signal source. With waveform parameter digital display, including frequency, period, pulse width, duty ratio, MAX. or MIN. or AVG. or Peak- Maximum real-time sampling rate: 1Msps Accuracy: 12Bit Sample buffer depth: 1024 bytes Analog Bandwidth: 0 - 200KHz Vertical Sensitivity: 10mV or Div - 5V or Div (in 1-2-5 increments) Adjustable vertical displacement with indication Input impedance: 1MΩ Maximum input voltage: 50Vpp (1:1 probe), 400Vpp (10:1 probe) Coupling methods include DC or AC or GND Horizontal time base range: 10μs or Div - 50s or Div (in 1-2-5 increments) With automatic, conventional and single trigger modes, it is convenient to capture instantaneous waveforms Trigger with rising or falling edge Adjustable trigger level position with indication Waveform before trigger can be observed (negative delay) Waveform display can be freeze at any time (HOLD function) Comes with 1KHz or 3.3V square wave test signal source Digital display with waveform parameters, the parameters that can be displayed are: frequency, period, pulse width, duty cycle, maximum value, minimum value, average value, peak-to-peak value, RMS Save or recall the waveform, the waveform does not disappear when power off Colour:Red Material:ABS Size:18 x 12.5 x 3cm Package Contents: 1 x DSO138 DIY Digital Oscilloscope Kit 1 x Probe Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different f Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.
  • Fruugo-ID: 445967718-936504096
  • EAN: 7438599604249

Leverans och returer

Skickas inom 2 dagar

  • STANDARD: GRATIS - Leverans mellan kl mån 22 december 2025–mån 29 december 2025 - GRATIS

Leverans från Kina.

Vi gör vårt bästa för att säkerställa att produkterna du beställer levereras kompletta och enligt dina specifikationer. Om du däremot skulle ta emot en ofullständig beställning, eller andra artiklar än de du beställt, eller om det finns någon annan anledning till att du inte är nöjd med din beställning, kan du returnera beställningen, eller valfria produkter som ingår i beställningen, och få fullständig ersättning för artiklarna. Visa fullständig returpolicy

Produktöverensstämmelsedetaljer

Vänligen se överensstämmelseinformationen som är specifik för denna produkt som beskrivs nedan.

Följande information tillhandahålls av den oberoende tredjepartsåterförsäljaren som säljer denna produkt.

Tillverkare:
Följande information beskriver kontaktuppgifter för tillverkaren av denna produkt som säljs på Fruugo.

  • Hefei Zheshuo Technology Co., Ltd.
  • Hefei Zheshuo Technology Co., Ltd.
  • Hefei City, Anhui Province, Shushan District, Anhui Province, No. 15, South Seventh Street, South Cooperative South Road, Chemical Machinery Community, Building 1, Unit 2, 603
  • Hefei
  • CN
  • 523011
  • nacufalacan81@hotmail.com
  • 13243801962

Ansvarig person i EU:
Följande information innehåller kontaktuppgifter för den ansvariga personen i EU. Den ansvariga personen är den utsedda ekonomiska aktör i EU som ansvarar för att skyldigheterna uppfylls för denna produkt som säljs till Europeiska unionen.

  • Jean Luc
  • In Memoria Futuri SAS
  • 3 RUE DU PAS DE LA MULE 75004 PARIS
  • Paris
  • France
  • 75004
  • infoapexchen@gmail.com
  • 33745713901