ECU Power Box Flash with Full Adapters 3 Switches ECU Openport for JTAG Works Item Type: ECU Device BoxMaterial: ABS Description: Device box is compatible in the automatic mode with the loading programs which use: for BOOT-OEM12, 12 pin OBD-II for L-LINE, 15 pin OBD-II. The Tool has built in current limiting resistors on the following signal lines: RESET - 510 Ω BOOT - 510 Ω CNF1 - 220 Ω Lights: Controls: The tool has 3 Switches for operating in different modes. POWER: Power control. The tool has three modes of power supply to the ECU: OFF allows to remove all power and control signals from IDC-26 and DB-15 connectors; MANUAL supplies power to VECU and VKEY terminals and to the control outputs depending on the chosen tactics; AUTO, automatic control, in this mode power is controlled by the loading program with for L-Line signal (15 pin OBD-II). BOOT: Simultaneous control of BOOT, RESET and CNF1 signals (3.3V): OFF, allows to remove all control signals from DB-15 connector; MANUAL pulls RESET and BOOT to the signal minus, and CNF1 to +3.3V; AUTO, automatic control, in this mode BOOT, RESET and CNF1 signals are simultaneously controlled by the loading program (12 pin OBD-II, OEM12). GPT: Used for Renesas and for Tricore with GPT CPUs. It is necessary e 5V while working with SH705x CPUs, in other cases 3.3V is to be used. The Tool Is Fitted With Multipurpose Connectors Which Allow To Establish The Connections Flexibly: USB: Designed for connecting to the computer. It is to be connected when the built-in USB - UART converter is enabled; DC: J2534 (OBD-II-F): Designed for connecting the same name interface to OBD-II; DB-15: Designed for connecting to the main ECU connector. It is recommended e 14P600KT02, 14P600KT03 cables or analogous ones; IDC-26: Designed for connecting directly to the ECU board or via the adapter to the special head. It is recommended e 14P600KT06 cable or an analogous one for Tricore GPT. It is recommended e for Flash Development Toolkit software for flashing for Renesas CPUs.