Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, for AirSpeed Linear Regulator Voltage adjustable, 5V Default, 6V or 7.2V via jumper Continuous current 2 Amps, 3A PeakMCU: STM32H743VIT6, 480MHz , 1MB RAM, 2MB Flash IMU: ICM42688-P(V3) & ICM42605 (SPI4) Baro: Infineon DPS310 (I2C2) OSD: AT7456E (SPI2) Blackbox: Micro-SD card slot (SDIO) 7x Uarts (1,2,3,4,6,7,8) with built-in inversion. 13x PWM outputs(including "LED" pad) 2x I2C 1x CAN 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, VB2, CU2) 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red) USBBeep Extender with Type-C(USB2.0) Dual Camera Inputs switch 5V9V(12V) for CameraVTX power switch High-precision Current Sense (90A continuous, 220A peak) Battery Voltage Sensor: 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot) ADC VB2 voltage divider: 1K:20K ADC AirSpeed voltage divider: 20K:20K Static power 160mA 5V for ArduPilot(ChiBiOS): MATEKH743 for INAV: MATEKH743 Input voltage range: 8-36V (3-8S LiPo) with TVS protection The product appearance and printed words may vary depending on the batch, but this does not affect use Colour:As Shown Material:PCBPackage Contents: 1set x flight controller accessoriesOnly the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +- 1-3cm.