Notice: 1. Install on Windows 7 (32-bit and 64-bit English system only). 2. Install the driver before launching the software; otherwise, the software will not open. Use only the driver provided on the included CD — do not use drivers from other MPPS versions. This module adds support for advanced ECU programming functions. MPPS supports a wide range of engine control units, including but not limited to: ME7xx, MED9, MED17, EDC15, EDC16, EDC17, Delco, Trionic, and others. - Automatic ECU and processor type detection — no manual selection required. - Read and write capabilities for EEPROM, IROM, and XROM (where supported). - OBD-based flashing for TPROT-enabled ECUs (currently supported models only). - TPROT status check feature — verify TPROT activation without opening the ECU. - Supports up to TP12 protocols. - Supports current ECUs without password protection. - Supports unlocking of Simos PCR2 and Simos 8 ECUs. - Checksum correction for MED17 ECUs. MPPS is a professional ECU programming tool offering: - General read/write operations and checksum calculation/support. - Enhanced communication capabilities — in some cases, it can establish connection with ECUs that other tools cannot access, even when memory is blank. - Selectable full or partial read/write (where ECU firmware permits). - Adjustable read/write speed settings. - “Write changes only” mode for faster programming (ECU-dependent). - Automatic K-Line/CAN bus detection, with option to manually select or force communication protocol. - Temporary immobilizer bypass for bench flashing on ME7 ECUs. - Boot mode support for ECUs using C167 and ST10 processors. - EEPROM read/write functionality for compatible ECUs. - Non-invasive TPROT level verification for MED17 ECUs. Color: Black Material: ABS Package Includes: - 1 × MPPS V18.12.3.8 interface device - 1 × Breakout Tricore cable - 1 × Pinout cable - 1 × Software CD Note: The package contains only the items listed above. Additional accessories or tools are not included. Color appearance may vary slightly due to lighting conditions and screen settings. Dimensions are subject to a tolerance of ±1–3 cm.