OPERATION TEST:Plug the test leads into COM and + sockets.Place the range selector to a prescribed range position.Short the test leads and turn 0A DJ to set the poin-ter to zero position.Make sure that there is no voltage cross the circuit to be tested.Connect the test leads to the tested resistor and read the scale in accordance with the reference table.CONTINUITY TEST (BUZZ) Set the range selector knob to BUZZ,apply the test lead pins to two points to be tested and test continuity.Then the buzzer will buzz at between 0 and about 120 .It is impossible to test a point where voltage is being applied.CONTINUITY TEST (LED). Set the range selectot to the""CONT'Y"" position.Connect thetest leads to the tested circuit if the""LED"" in the tester produce light that mean the tested circuit is continuous.SURFACE MOUNT TECHNOLOGY.POLARITY SWITCH FUNCTION.10A DC CURRENT MEASUREMENTS.FUSE AND DIODE PROTECTIONAnalog Multimeter with Mirror Scale Inbuilt Buzzer and LED 0 Adjustment with X 100 Range Transistors Test , hFE with Diode.Test Resistance Range : X1 , X10 , X100 , X1K , X10KSpecial Functions:Diode Test TransistorTesting Continuity Buzzer About 100 Function Protection Iceo : 150A - 15mA - 150mAAC Voltage (Volts)10-1000VAC Voltage Accuracy4%DC Voltage (Volts)0.1mV-1000VDC Voltage Accuracy3%DC Current (Amp)50A-10ADC Current Accuracy3%Resistance (Ohm)0.2 -20 MResistance Accuracy3%hFE( TR Amplification factor) 0-1000Size (mm)148x100x35 mm Includes Test Leads,Package includes:1 x Multimeter1 x Manual1 Pair Test Pen