1. Latest ELM327 version for improved Ford compatibility 2. Modified with a switch to connect to different CAN buses 3. Designed for use with FORScan software 4. Compatible with software vendors: FORScan, Elmconfig (supports Baud rate: 34800, please verify before ordering), FF2, and FoCCCus, among others Basic Features: Reset fault/trouble codes/parameter IDs (PIDs), change vehicle configuration data, run tests, perform service procedures Supports MS CAN bus and HS CAN bus ELM327 USB 25k80 With Switch For Ford Diagnostic Cable Product Introduction: This ELM327 OBDII OBD2 USB cable features a switch and is designed for use with Ford and Mazda vehicles. With this cable and compatible software, you can access vehicle modules not visible to standard OBD2 scanners. It enables reading trouble codes, PIDs, running tests, and performing service procedures beyond the capabilities of standard OBD2 scanners and basic ELM327 devices. Pin Configurations: Switch outside: HS CAN Uses pins 6 and 14 Switch inside: MS CAN Uses pins 3 and 11 Supported Software: FORScan Elmconfig (supports Baud rate: 34800, please verify before ordering) FoCCCus Modified ELM327 Information: Many Ford and Mazda models from approximately 20032004 onward are equipped with an MS CAN bus in addition to the standard HS CAN bus. Unlike HS CAN, which complies with OBD2 standards and uses pins 6 and 14, MS CAN uses non-OBD2 pins (3 and 11) and is manufacturer-specific, making it unsupported by standard ELM327 devices. This device has been modified to support MS CAN bus communication. HS CAN support is standard on ELM327 as it aligns with OBD2 specifications. Color: As shown Material: ABS Package Contents: 1 x Diagnostic Scan Tool Note: Only the item listed above is included; other accessories are not included.