Description for Mini One Cooper S Convertible R52 (2001-2006) rear hood soft top weather rubber seal repair self adhesive. This DIY rubber repair kit is designed to replace the worn, cracked, or damaged rear weather seal on the soft top of the Mini Convertible R52. It replaces the rubber strip located above the chrome trim, which runs along the rear edge above the boot and quarter panels—the area most prone to aging, sun exposure, and weather damage. The seal is made with self-adhesive 3M tape and measures approximately 2 meters in total length. Minor trimming may be required to fit around the third brake light and to adjust the length. Installation Instructions: Step 1: Clean the surface thoroughly to ensure maximum adhesion. Step 2: Position the new rubber strip over the prepared area, aligning it with the edge where the old rubber was removed. Press firmly into place, ensuring it overlaps slightly onto the roof material for a secure seal. Note: Proper alignment is critical, as the adhesive bonds quickly. A slight increase in profile may be visible where the rubber overlaps the chrome, but this improves sealing performance and helps protect ing from UV exposure. This repair solution has been tested through multiple seasons in various weather conditions. For best results, avoid high-pressure washing of the roof area. Clean gently with a sponge and water. For added security, consider applying a small amount of cyanoacrylate adhesive (not included) in concealed areas to prevent lifting due to movement. Alternatively, a bead of silicone sealant can be used if needed. To facilitate installation, the strip can be removed and pre-cut away from the vehicle to avoid accidental damage to the roof fabric. Tamper-proof torx screws located under the chrome trim can be accessed by releasing the side latches (boot loading mode), allowing the lower roof section to be tilted upward. Support the roof with a suitable prop during work. Package includes: 1x replacement self-adhesive rubber seal